DraughtEx FAQs
- Q - Is DraughtEx visible when it is fitted and what colour is it manufactured in?
- A - DraughtEx is manufactured in “shadow”, a grey/black colour that is designed to match the natural shadow created by wooden floorboards. Although DraughtEx can be seen, it completes the look of floorboards, leaving you with an efficient and attractive finish. Take a look in our Photo Gallery for examples.
- Q - When’s best to insert DraughtEx? Does inserting into floorboards cause any damage?
- A - The best time to fit DraughtEx is after sanding and finishing the floorboards themselves. Draughtex can then be applied to gaps without detriment to the boards themselves. Application is easy and does not damage laid floorboards.
- Q - How do I know how much DraughtEx will be needed and how many rolls to buy?
- A - DraughtEx is supplied in rolls of either 10m (gaps between 6-12mm) or 40m (2-8mm). The calculator on the homepage can be used to make an accurate estimation of how much DraughtEx will be needed.
- Q - What happens to the cold air drafts after DraughtEx has been fitted between floorboards?
- A - By inserting DraughtEx into your floorboards you are sealing the cold air under the floorboards and out of your living space. This means that the temperature in the room with DraughtEx fitted will not be compromised.
- Q - Can I not fill my floorboard gaps with anything?
- A - You can fill floorboard gaps with any material and it will work for a period of time if it is air-tight sealed. Draughtex is designed to guarantee this seal. As with all wooden floors the timber moves and this can dislodge sealants rendering them useless and allowing draughts to again flow through the gaps.
- Q - Can I vacuum the floor without sucking out DraughtEx?
- A - Vacuuming the floor should not suck up DraughtEx or dislodge it. Draughtex is suitable for applying to gaps 2–8 mm and will usually sit 5mm below the surface of your floorboards.
- Q - Is there a helpline for DraughtEx, and when can I call?
- A - We have a dedicated free phone number dedicated to sales and support, 0800 088 7311 open Monday to Friday (09:00 – 16:00).
- Q - Can I paint or treat the floorboards after I have fitted DraughtEx?
- A - DraughtEx should only be fitted on floorboards that have been completely finished. Installation of DraughtEx should be the final step of any work taking place on floorboards as the effectiveness of this gap sealant can be compromised if it is coated with solutions. The application of DraughtEx has been designed to ensure that it is not only simple to insert, but also so that it does not damage floorboards when using the tools suggested and supplied with the product.
- Q - Can DraughtEx be applied to Tongue and Groove?
- A - Tongue and groove floorboards often haven’t got the right dimensions that are necessary to apply Draughtex. The gap between the floorboards needs to be at least 10mm deep and between 2-12mm wide.
